How to Power On and Off Your CommBox Meeting Room Display Gen 2

Applies To

CommBox Meeting Room Display Gen 2 — All models

Step-by-Step Instructions

Step 1: Connect the Power Cable

• Plug the power cable firmly into the back of the screen
• Connect the other end to a power point
• The screen supports AC 100–240V and is compatible with standard Australian power outlets

Step 2: Turn On the Rear Power Switch

• Locate the power switch on the rear of the screen
• Switch it to the ON position
• The power indicator light on the front of the screen will glow

Step 3: Turn On the Screen

• Short press the Power button on the remote to turn it on, or
• Long press the Power button on the screen itself
• The screen will display the CommBox logo before showing your last used input

Step 4: Turn Off the Screen

• Long press the Power button on the remote, or
• Long press the Power button on the screen
• The indicator light will turn off or switch to standby

💡 Tip: Use the remote for day-to-day power on and off. The rear power switch is for full shutdowns — for example, when cleaning or moving the screen.

⚠️ Important: Do not unplug the screen while it is turned on. Always power it off first using the Power button before disconnecting the power cable.

Troubleshooting / What to Do If It Doesn't Work

• Power light not turning on — check the cable is firmly connected at both ends and the power point is switched on
• Screen turns on then immediately turns off — ensure vents are not blocked and the screen has adequate ventilation
• Remote not responding — check the batteries are correctly inserted and aim directly at the sensor on the front of the screen
• If you need help, log a ticket on the Support Portal in Knowledge Base: https://support.commbox.com.au/knowledge/kb-tickets/new

Video Tutorial

Refer to the CommBox Support Portal for guided videos at support.commbox.com.au